Internal Coating, PowerKote?

FOR USE ON: PISTONS COMBUSTION CHAMBERS VALVES PORTS

3oz will cover aprox. 24 4 inch round pistons Stir and Shake before use All parts must be clean of all oils, dirt or other debris. Water based no hazardous fumes, non flammable. Blast lightly with 10X EpiX Blasting Media MP 70/100 Grit (EPIX), or 120 grit aluminum oxide at low pressure. Degrease with Columbia Coatings Super Degreaser (SD-MTO25) or similar non petroleum based solvent. After STIRRING and shaking ( mix in a blender) then apply coating. Spray at an air pressure of about 60 psi through a fine nozzle ( 1mm or less). Allow to dry to a gray/white finish. Bake at a minimum of 350f for 1 hour. Inspect part after cure for blisters, cracking or flaking. Reduces part temperature. Keeps heat in combustion chamber longer, through the power stroke. Reduce fuel consumption. DO NOT ASSEMBLE IF DAMAGE VISIBLE Polish with 0000 steel wool and a polishing compound. Water Based Paint Use Water For Cleanup DANGER: Contains aluminum powder and phosphate /chromic solution. Contact with soaps or strong alkalis may produce hydrogen gas causing fire or explosion hazard. DO NOT use water to extinguish fire. Danger: Do not breathe vapors or mists from spraying. Avoid contact with skin and eyes. Use with adequate ventilation to maintain exposure levels below established exposure limits (see MSDS). If required wear an appropriate NIOSH approved respirator with paint pre-filter. FIRST AID: Skin- Flush with water. Eyes-Flush with plenty of water. IF SWALLOWED- Drink plenty of water and milk of magnesia and GET MEDICAL ATTENTION EMERGENCY 1-800-424-9300

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov